Difference between revisions of "Makerspace 3D and 2D"

From DiLab
Jump to: navigation, search
(Inkscape for Laser cutting)
(Problem2: unittouu)
Line 37: Line 37:
 
The solution is to update the gcodetools.py as follows. For me, this was on the line 5864 where unittouu is called.
 
The solution is to update the gcodetools.py as follows. For me, this was on the line 5864 where unittouu is called.
 
The problem is that it is referenced as  
 
The problem is that it is referenced as  
  inkex.unittouu(...
+
  doc_height = inkex.unittouu(...
 
Fix this as follows:
 
Fix this as follows:
  self.unittouu(...
+
  doc_height = self.unittouu(...
  
 
= Topics =
 
= Topics =
 
* [[Topo_to_3D | No topogrāfiskajām kartēm līdz drukājamam 3d modelim]]
 
* [[Topo_to_3D | No topogrāfiskajām kartēm līdz drukājamam 3d modelim]]

Revision as of 22:44, 31 December 2019

Leo's notes about 2D and 3D design and tools.

2D - Laser Cutting and engraving

Life cycle:

  1. Design the 2D object (Inkscape, or any graphical editor)
  2. Export to a compatible format: Gcode or DXF
  3. Send to the laser cutter

Inkscape for Laser cutting

Good and short tutorial videos:

Notes: about Inkscape and Linux

Problem1: python 2.7 vs 3 for gcodetools

  • There is an extension for Gcode export.
  • It appears to be written for Python 2, while the newest Inkscape appears to be running Python 3. There might be problems with running the extensions. Change the default version for python to be 2.7 like this:
    • Open Inkscape preferences, usually here: ~/.config/inkscape/preferences.xml
    • Search for
<group
    id="extensions"
    …
    org.ekips.filter.gears.pitch="20"
    org.ekips.filter.gears.angle="20" />
    • Change to - add the following:
<group
    id="extensions"
    python-interpreter="/usr/bin/python2.7"
    …
    org.ekips.filter.gears.pitch="20"
    org.ekips.filter.gears.angle="20" />

Problem2: unittouu

After running gcodetools extension you may get

AttributeError: 'module' object has no attribute 'unittouu'

The solution is to update the gcodetools.py as follows. For me, this was on the line 5864 where unittouu is called. The problem is that it is referenced as

doc_height = inkex.unittouu(...

Fix this as follows:

doc_height = self.unittouu(...

Topics