Difference between revisions of "Dev:cc3200"
(→Notes for Linux) |
|||
| Line 1: | Line 1: | ||
TI Chip with Arm Cortex M4 and network processor with ipV4 in hardware. |
TI Chip with Arm Cortex M4 and network processor with ipV4 in hardware. |
||
= Code Composer studio on Linux = |
|||
* [http://processors.wiki.ti.com/index.php/Linux_Host_Support_CCSv6 TI CCS v6 wiki] |
|||
= Notes for Linux = |
= Notes for Linux = |
||
== Serial connection == |
== Serial connection == |
||
| Line 17: | Line 25: | ||
sudo apt-get install binutils-arm-none-eabi gdb-arm-none-eabi gcc-arm-none-eabi libnewlib-arm-none-eabi |
sudo apt-get install binutils-arm-none-eabi gdb-arm-none-eabi gcc-arm-none-eabi libnewlib-arm-none-eabi |
||
sudo apt-get install openocd |
sudo apt-get install openocd |
||
= Resources = |
= Resources = |
||
Revision as of 17:47, 10 December 2014
TI Chip with Arm Cortex M4 and network processor with ipV4 in hardware.
Contents
[hide]Code Composer studio on Linux
Notes for Linux
Serial connection
Enable recognition for the serial USB connection, which is a FTDI chip with TI codes:
sudo su modprobe ftdi-sio echo 0451 c32a > /sys/bus/usb-serial/drivers/ftdi_sio/new_id
Alternative: use this udev rule:
ATTRS{idVendor}=="0451", ATTRS{idProduct}=="c32a", MODE="0660", GROUP="dialout", RUN+="/sbin/modprobe ftdi-sio", RUN+="/bin/sh -c '/bin/echo 0451 c32a > /sys/bus/usb-serial/drivers/ftdi_sio/new_id'"
Tools
Install arm tools. May have to remove gdb first.
sudo apt-get remove gdb sudo apt-get install binutils-arm-none-eabi gdb-arm-none-eabi gcc-arm-none-eabi libnewlib-arm-none-eabi sudo apt-get install openocd
